Turbocharger Technician's Guide from Detroit Company
2 مشترك
صفحة 1 من اصل 1
Turbocharger Technician's Guide from Detroit Company
Turbocharger Technician's Guide from Detroit Company
كورس جامد جدا عن الــTurbocharger
[SIZE=3]A turbocharger is a small radial fan pump driven by the energy of the exhaust gases of an engine. A turbocharger consists of a turbine and a compressor on a shared shaft. The turbine converts exhaust heat and pressure to rotational force, which is in turn used to drive the compressor. The compressor draws in ambient air and pumps it in to the intake manifold at increased pressure, resulting in a greater mass of air entering the cylinders on each intake stroke.
The objective of a turbocharger is the same as a supercharger; to improve the engine's volumetric efficiency by solving one of its cardinal limitations. A naturally aspirated automobile engine uses only the downward stroke of a piston to create an area of low pressure in order to draw air into the cylinder through the intake valves. The pressure in the atmosphere is no more than 1 atm (approximately 14.7 psi), so there ultimately will be a limit to the pressure difference across the intake valves and thus the amount of airflow entering the combustion chamber. Since the turbocharger increases the pressure at the point where air is entering the cylinder, a greater mass of air (oxygen) will be forced in as the inlet manifold pressure increases. The additional air flow makes it possible to maintain the combustion chamber pressure and fuel/air load even at high engine revolution speeds, increasing the power and torque output of the engine.
To avoid detonation and physical damage, the pressure in the cylinder must not go too high, to prevent this the intake pressure must be controlled by venting excess gas. The control function is performed by a wastegate, which routes some of the exhaust flow away from the turbine. This regulates air pressure in the intake manifold.
والان مع الصور
رابط التحميل
http://www.multiupload.com/GM4E3A1NTZ
كورس جامد جدا عن الــTurbocharger
[SIZE=3]A turbocharger is a small radial fan pump driven by the energy of the exhaust gases of an engine. A turbocharger consists of a turbine and a compressor on a shared shaft. The turbine converts exhaust heat and pressure to rotational force, which is in turn used to drive the compressor. The compressor draws in ambient air and pumps it in to the intake manifold at increased pressure, resulting in a greater mass of air entering the cylinders on each intake stroke.
The objective of a turbocharger is the same as a supercharger; to improve the engine's volumetric efficiency by solving one of its cardinal limitations. A naturally aspirated automobile engine uses only the downward stroke of a piston to create an area of low pressure in order to draw air into the cylinder through the intake valves. The pressure in the atmosphere is no more than 1 atm (approximately 14.7 psi), so there ultimately will be a limit to the pressure difference across the intake valves and thus the amount of airflow entering the combustion chamber. Since the turbocharger increases the pressure at the point where air is entering the cylinder, a greater mass of air (oxygen) will be forced in as the inlet manifold pressure increases. The additional air flow makes it possible to maintain the combustion chamber pressure and fuel/air load even at high engine revolution speeds, increasing the power and torque output of the engine.
To avoid detonation and physical damage, the pressure in the cylinder must not go too high, to prevent this the intake pressure must be controlled by venting excess gas. The control function is performed by a wastegate, which routes some of the exhaust flow away from the turbine. This regulates air pressure in the intake manifold.
والان مع الصور
رابط التحميل
http://www.multiupload.com/GM4E3A1NTZ
الموضوع منقول من [URL="http://ebiedyousif.net/vb/t22946.html"]منتديات خبير.نت[/URL]
الموضوع الاصلي هنا
http://ebiedyousif.net/vb/t22946.html[/size]
bedoo54- مهندس مشارك
- تاريخ التسجيل : 07/06/2010
رد: Turbocharger Technician's Guide from Detroit Company
الموضوع ده مهم جدا في تقليل وزن المحركات و زيادة كفاءتها و خصوصا في المعدات الثقيلة
الملفات مساحتها صغيرة و رائعة جدا....شكرا لمشاركتكـ
الملفات مساحتها صغيرة و رائعة جدا....شكرا لمشاركتكـ
maesegyptisA- مشرف قسم هندسة القوى الميكانيكية والطاقة
- تاريخ التسجيل : 10/03/2010
صفحة 1 من اصل 1
صلاحيات هذا المنتدى:
لاتستطيع الرد على المواضيع في هذا المنتدى
الأربعاء سبتمبر 03, 2014 9:50 pm من طرف Ahmed mahmoud
» ملتقى التوظيف الثامن عشر بكلية هندسة جامعة القاهرة من يومى 28/29 ابريل
الجمعة أبريل 26, 2013 5:38 am من طرف egyptian boy
» Java Standard Edition(J2SE) in Cairo By AMIT Learning
الإثنين فبراير 04, 2013 4:17 pm من طرف soha hamdy
» دبلومة الاي فون (iPhone) فى مصر فى مركز AMIT Learning
السبت فبراير 02, 2013 8:45 pm من طرف Fateema Ahmed
» طلب مساعده ضرووووووووووووووورى
السبت مايو 19, 2012 10:09 pm من طرف arc_hossam
» كورس الاى فون ( iphone course in AMIT Learning)
الثلاثاء أغسطس 16, 2011 5:16 pm من طرف rotna
» iPhone Development Diploma in Egypt
الإثنين أغسطس 08, 2011 3:06 pm من طرف rotna
» لو انت طالب من دفعة إعدادي الجديدة يبقى تدخل هنا
الثلاثاء أغسطس 02, 2011 11:27 am من طرف мя. ρħ∂ήţσм
» Embedded Software Diploma In Egypt
الثلاثاء أغسطس 02, 2011 4:12 am من طرف rotna
» TOEFL IBT & IELTS TEST PREPARATION COURSE WITH EMAN HAFEZ IN EGYPT In AMIT Learning
الأربعاء يوليو 20, 2011 7:32 pm من طرف rotna
» TOEFL IBT & IELTS TEST PREPARATION WITH EMAN HAFEZ IN EGYPT In AMIT Learning
الإثنين يوليو 18, 2011 8:15 pm من طرف rotna
» TOEFL IBT & IELTS TEST PREPARATION WITH EMAN HAFEZ IN EGYPT In AMIT Learning
الإثنين يوليو 18, 2011 7:57 pm من طرف rotna
» Embedded Systems Diploma in AMIT Learning
الخميس يوليو 07, 2011 6:16 pm من طرف rotna
» اغتنم فرصة 70 % دعم لدورتي CCNA + MCITP من pioneers Academy
الأحد يونيو 26, 2011 4:00 pm من طرف angel_eye
» ENHANCE YOUR ENGLISH DIPLOMA In AMIT Learning
السبت يونيو 25, 2011 8:45 pm من طرف rotna